NON
SOLO
SENSORI

Home
Novità
Prodotti
Servizi
Download

 

contattare FAE

telefoni

internat. pref. ++39 (Italy)

phone 02.55.187.133 ric. autom.

fax 02.55.187.399

e-mail:

informazioni generali: fae@fae.it

ufficio vendite: vendor@fae.it

supporto tecnico clienti: tech@fae.it

• High resolution (1µm)

• Operating distance up to 25m

• Short reaction time

• Menu control by Touch Panel on backlit display

• Indication of the measured coordinates in combined graphic and numerical format

• Large format numerical display for best reading from a longer distance

• USB-interface for data protocol

• Operation from mains supply or independent battery power

• Solid execution for mobile use

• Customization of mechanical interfaces on request

As its predecessor, the positioning system PSD 10 has been developed especially for the precise alignment of machines or their components to each other.

The measuring system consists of a laser sender, a receiver, a controller unit for the display and system operation, and a mains adaptor. The laser sender emits a modulated laser beam which projects on the 2-dimensional sensor surface within the receiver. The receiver converts the geometrical coordinates of the laser beam into digital signals which are sent to the controller unit. 

The Data is shown on the large LCD display in the controller unit. The display shows the coordinates, the set parameters and the menu functions available. The system operation is simple and all functions are accessible entirely by the display’s Touch Panel.

The laser beam position is shown on the display in both, numerical and graphical format (as a circle within a scaled cross hair). Special function keys allow a zooming of the cross hair, setting of the zero point for relative measurements and a print out command. The entire right side of the display works as a touch key to access further menu functions. These allow the adjustment or selection of the following settings:

• Set display format in horizontal or vertical shape,

• Selection of filter to stabilize the displayed values,

• Indication of the laser beam centre in cartesian or polar coordinates,

• Selection of the numerical format in mm or µm,

• Indication of the angular deviation in radiant or degrees when using the polar display format,

• Selection of an absolute or relative measurement centre,

• Choice of menu language in English or German,

Further access to settings which influence the laser safety or other technical parameters, are password protected.

When the zoom setting is such that the laser beam centre is outside the cross hair display, a large arrow shows the direction in which the laser beam is positioned.

The USB-interface allows the transfer of the measurement data (X-/Y-value) to a computer for record keeping and/or evaluation.

CONTROLLER UNIT

Unless indicated otherwise, the above data is correct at ambient room temperature and normal operating conditions.

1) Driver required on PC for communicating with PSD-10 controller unit.

SENDER

TECHNICAL DATA SENDER

Unless indicated otherwise, the above data is correct at ambient room temperature and normal operating conditions.

1) Laser power adjustment for measurements under difficult conditions is password protected.

RECEIVER

TECHNICAL DATA RECEIVER

PSD10 - RECEIVER
Operating voltage	12	Vdc
Max. operating courrent	<30	mA
Active receiver surface	10 x 10	mm
Protection class	IP65	-
Plug	shielded RJ45 plug with lock	-
Weight	0,24	Kg

Unless indicated otherwise, the above data is correct at ambient room temperature and normal operating conditions.

POWER SUPPLY ADAPTER

Scarica le specifiche tecniche

Torna alla pagina dei laser

Aggiornato il 03 novembre 2007